Stage 1 remap in Greater Manchester

Software only, no parts. A Stage 1 remap typically gives a turbo petrol or diesel 20–35% more power and a stronger mid-range, and we do it at your home or workplace.

What a Stage 1 remap is

Your engine's control unit (ECU) runs on software that sets fuel, boost, ignition timing and torque limits. Manufacturers leave a margin so one calibration suits every market, fuel quality and driver. A Stage 1 remap adjusts that software for your car on standard hardware, staying inside the safe limits of the engine, turbo, clutch and gearbox.

You feel it most in the mid-range: stronger pull from 1,800 to 4,000 rpm, easier overtaking and less need to change down on hills or with a load on board.

Typical gains

These are the planning factors we use for estimates. Real figures for your car are confirmed after diagnostics.

EnginePowerTorqueExample: stockExample: Stage 1
Turbo diesel+25%+30%150 hp / 320 Nm188 hp / 416 Nm
Turbo petrol+20%+25%180 hp / 280 Nm216 hp / 350 Nm
Hybrid+15%+18%122 hp / 200 Nm140 hp / 236 Nm

Work out your own car's figures with the Stage 1 remap calculator, or see how we estimate gains.

Who it suits

  • Turbo petrol and diesel cars on standard hardware
  • Drivers who want stronger in-gear performance rather than a louder car
  • Vans and 4x4s that tow or carry loads (see van and fleet remapping)

When we say no: if diagnostics show a fault, a slipping clutch, a failing turbo or a blocked DPF, we fix or report that first. A remap never hides a problem.

What's included

DiagnosticsFault codes and live data before and after
Original fileBacked up, so you can return to standard at any time
WhereYour home, work or depot, anywhere in Greater Manchester
Time on siteUsually 1–2 hours
Guarantee30-day satisfaction guarantee
PriceQuote in 24 hrs, fixed before we book, paid on completion

How the visit works

  1. Diagnostics. We read fault codes and live data, and check the engine is healthy before anything changes.
  2. Backup. The original software is saved, so the car can always go back to standard.
  3. The map. We write the new calibration through the diagnostic port, or on the bench if the control unit needs it.
  4. Final checks. Codes cleared, live data checked, and a run-through with you before we leave.

Gearbox and Stage 1+

Automatic and DSG gearboxes have their own torque limits. If yours would hold back the new engine map, we recommend a gearbox (TCU) remap at the same visit. Cars with an upgraded intake, intercooler or exhaust can have a custom map built around that hardware.

Questions

How much power does a Stage 1 remap add?

On most turbo diesels around 25% more power and 30% more torque, and on turbo petrols around 20% and 25%. Figures for your exact engine are confirmed after diagnostics.

Is a Stage 1 remap safe?

Yes, when the map stays inside the limits of the engine, turbo, clutch and gearbox, which is all we write. We check the car first and will not remap a car with faults.

Do I need to tell my insurer?

Yes. A remap counts as a modification, so tell your insurer before the car is driven.

Can it be reversed?

Yes. We save your original software before changing anything and can write it back whenever you need.

How long does it take?

Usually 1–2 hours at your home or workplace.

Areas we cover

We visit homes, workplaces and depots in all ten Greater Manchester boroughs:

Related reading

Get a fixed price

Send your reg and we reply within 24 hours with a fixed price, the gains to expect and the earliest slot near you.